20 Vartag

[Tiratore]

Its really not that bad turning necks, I do alot i use K&M stuff no complaints.

Me too.

 

[TheCZKid]

I use a Shars tube micrometer, with thin metal rod, to get into the 17 caliber necks

Shars 0-1" Tube Micrometer with Pin Anvil, .0001" Graduation 303-2350 P: Amazon.com: Industrial & Scientific

Shars 0-1" Tube Micrometer with Pin Anvil, .0001" Graduation 303-2350 P: Amazon.com: Industrial & Scientific

www.amazon.com

 

[Rick in Oregon]

I use the same tubing mic, except mine is a Mitutoyo.
Most tubing mic's will measure to the 4th place decimal, plenty accurate enough for case neck thickness measurements.
And accuracy is what it's all about, right?

 

[KevinG]

My old neck turning/checking setup.
I've since built a gearmotor drive for case work.

Kevin