Tiratore
Member
Me too.
20 Vartag
- Thread starter DamDave
- Start date
TheCZKid
Active member
I use a Shars tube micrometer, with thin metal rod, to get into the 17 caliber necks
Shars 0-1" Tube Micrometer with Pin Anvil, .0001" Graduation 303-2350 P: Amazon.com: Industrial & Scientific
Shars 0-1" Tube Micrometer with Pin Anvil, .0001" Graduation 303-2350 P: Amazon.com: Industrial & Scientific
www.amazon.com
Rick in Oregon
Active member
I use the same tubing mic, except mine is a Mitutoyo.
Most tubing mic's will measure to the 4th place decimal, plenty accurate enough for case neck thickness measurements.
And accuracy is what it's all about, right?
Most tubing mic's will measure to the 4th place decimal, plenty accurate enough for case neck thickness measurements.
And accuracy is what it's all about, right?
TheCZKid
Active member
K&M has a nice set-up. The neck turner can be put in a grip which makes it a lot easier to control. And, they have a case holder you can put in a drill motor, and an outer housing which makes it easier to use. I ended up putting rubber Talon grip material on the outside, so I'm able to tighten the case in the shell-holder.
You think hand held is better than a bench mount unit?
TheCZKid
Active member
I've only done it this way, so I don't have a comparison. It works well for me, I have done many thousand cases, as I use and also sell 20 Vartarg brass, plus now turn for 221 FB, 20 Practical and 17 Mach IV. I started doing my 22-250 cases recently, as I see the practical reason for it. If it's just to skim turn necks, to make them more uniform, so they have more consistent neck tension, and such.
kiwishooter
Active member
I like the larger adapter that holds the neck turning tool, is it just a round piece of aluminium with a slot for the tool?
After spending most of my life working spanners I have a bit of carpel tunnel so any prolonged use of smaller tools i end up with quite a bit of pain.
The latter Sinclair neck turning tool and the Pumpkin are a lot less painful to use.
kiwishooter
Active member
I built a gear motor set up quite a few years ago, what speed does yours turn at?
IIRC........it's a Baldor 1/8hp right-angle gearmotor.....172rpm.....41 inch-pounds of torque. I think I've a pic somewhere.
I use the K&M carbide neck-turning pilots exclusively..........i.e. no galling and leaves a very smooth burnished neck-wall interior.
For more neck-wall thickness uniformity.......I go at a moderate pace, to keep the turner at a moderate temperature......and not overheat.....causing neck thickness "drift".
From the pic......you can see the Ferguson's gage I use for checking neck-wall thickness runout (T.I.R.)..........to insure that the setup does indeed turn necks within 0.0001" T.I.R.
I check every turned case.
Kevin
Similar threads
